• + 44 (0) 1709 880 550
CE Approved

About Us

Daver Steels Bar & Cable Systems manufacture the Daver Tie Rod system and the Daver Compression Strut system. Both systems are high strength structural components with a high specification finish for constructional and architectural applications.

Daver Tie Rod System:-

Davers Tie Bar System

Daver Steels structural tie rod system is produced in carbon steel and stainless steel with a characteristic yield strength of 520 N/mm2 and are CE approved to Execution Class 4 (EXC4) BS EN 1090-1:2009 + A1:2011.


Daver Steels DST520 system provides a technical solution to your tie rod requirements. We have a wide range of experience with tie rod systems and can offer assistance to architects, designers, structural steel fabricators and end users.

Our standard range of fork end tie rods, complete with pins, lock covers and turnbuckles enables us to offer tension rod assemblies from:

  • M12 to M100 in carbon steel

  • M12 to M56 in stainless steel.

DST520 tendons are pre-assembled in the factory and set to their nominal pin-to-pin length for immediate incorporation into the structure.

Daver Steels have the experience and expertise to manufacture special components and system arrangements for your specific needs.

Daver Compression Strut System:-

Davers Compression Strut System

Daver Steels manufacture a range of adjustable compression struts in carbon steel and stainless steel. Both systems are supplied with CE certification up to Execution Class 3 (EXC3) BS EN 1090-1:2009 + A1:2011

The compression strut comprises of a central tubular section with threaded fork-end and pin connection at each end.

The Daver Compression Strut system is available in:

  • carbon steel from M12 to M100

  • stainless steel system from M12 to M56.

Daver Compression Struts are pre-assembled in the factory and set to their nominal pin-to-pin length for immediate incorporation into the structure.

Steel Fabrication, Sheared Plates & Cold Formed Sections:-

Steel BracketSteel BracketSteel Section

Daver Steels produce sheared plate, cold formed angles and channels in both carbon and stainless steel. We service the metals trade, steel stockists, fabricators, engineers and contractors.

Daver Steels are a CE approved fabricator to Execution Class 2 (EXC2) BS EN 1090-2:2008 + A1:2011.  We produce complete fabrications in carbon and stainless steel for applications in structural steel work, timber engineering, brick and stone support brackets, solar shading, glass façade engineering, and general fabrications.